7'4" Tanner Hull FathersDay227'4" x 22" x 3 1 8" Shaped by Tanner Prairie of Costa Mesa, this board is a nod to the displacement hulls of the late 1960s. The outline is very similar to the displacement sleds of that era, however, the nose and tail are slightly more pulled in, making for better maneuverability from the front half of the board. The rails are also moderately altered from the classic foil of displacement hulls; they are a tad fuller allowing for full rail engagement
The sweet spot for the Mega Fishes are much further back than you'd expect
50/50 mid way through the board
This allows the board to respond with minimal strength being applied and allows the board to fit more easily into critical sections of the wave
Mohinders is based in San Fransciso and India
Check out the Discos and one of Al's personal logs by becoming a member of the Daydream Research Center
The outline of the Fluer exhibits a centered wide point with a blunt full nose juxtaposed by a pulled in pin tail
perfectly balanced pour over coffee for one
Looking to test out one of Griffin Stepanek's Fish
you'd never believe that it hides as much thickness in the center since over an inch of foam is shaved down by the time it's been tapered to it's 50/50 rail which keeps its rounded shape all the way throughout the tail
The rods and cones send the color frequencies through the optic nerve to the brain and to the pineal glands
The outline is made up of pulled in nose and tail with the wide point running in the center of the board
Fully lined with 4-way stretch
