Parker-Hale Handstop Only, No Spigot, for Parker-Hale Bipod brand_-Flextone

Parker-Hale Handstop Only, No Spigot, for Parker-Hale Bipod brand_-FlextoneThis is the handstop section of Parker Hale's two part bipod mounting system, supplied on its own without the spigot. The handstop is the body that fits to your rifle's forend in place of the standard stud, and the matching spigot (sold separately) then seats in it to carry the Parker Hale bipod, the all steel, UK made design that stalkers and target shooters have trusted for decades. Buy this part if you already have a spigot, want to set up a second

as required under UK law

0 has up to 9 hours of continuous operation and is powered by both built-in rechargeable batteries and a replaceable external battery

and a retractable recoil stop pin adds a further layer of security under hard recoil

holding tighter tolerances than conventional cut or button-rifled liners and producing a consistent surface finish along the full 600mm of the bore

Sensor: 384×288px @ 12µm

The Maxima QD rings sport the unique Warne indexable lever system which allows the user to remove the optics from the rifle then reattach it without the loss of zero

very soft and comfortable

The fabric is a stretchable ripstop polyester bonded with tricot

it allows clean

Keeping a cylinder tube in the choke wallet means you can switch a multi-choke KOFS 12-bore over to close-range work in a couple of minutes

but any standard-drive battery tool will do the job

widely used in deer stalking and precision rifle competition