Holley - Inlet Needle Steel Seat Size 0.120", Adjustable

Holley - Inlet Needle Steel Seat Size 0.120", Adjustable"Steel tipped" inlet needles are necessary when using exotic racing fuels A . 097" seat size should be used for small four barrel carburetors; a . 110" seat size should be used for carburetors up to 735 CFM; larger seat sizes should be used with carburetors 750 CFM and larger. The following steel inlet needle and seat assemblies are available from Holley.

Harness End - Bolt-In - 2 in Slit - Steel - Zinc Plated - Pair

875 in OD - 15 in Long - 5/8-18 in Right Hand Female Thread - 5/8-18 in Left Hand Female Thread - DOM - Steel - Black Powder Coat - Each

Engine Oil Pan - Drag / Road Race - Front Sump - 7 qt - 6 in Deep - Baffled - Aluminum - GM LS-Series - Each

Muffler - CrateMuffler - 2

Jack Bolt - 1-8 in Thread - 11 in Long - Steel - Cadmium - Detented Weight Jack System - Each

If you damage a harness or are simply rewiring a car

00-inch mandrel-bent stainless steel tubing flowing into a specially designed dual 3

Chain Lube - Chain Guard - Synthetic - 14

Helmet - GT6 Carbon - Full Face - Snell SA2025 - FIA Approved - Head and Neck Support Ready - Carbon Fiber - Size 7-1/4 - Each

3 - Single Layer - Fire Retardant Cotton / Aramid Fiber - Black - One Size Fits All - Each

Cylinder Head - Victor - Bare - 2

Weather Pack Housing - Male - 2 Pin - 12V - 20 amps - Plastic - Black - Set of 10